Portable Grit Blaster
|
Portable Grit Blaster - PLCS recommends Clemco Model 1042, 1 Cu. ft. Classic Blast Machine System or similar for any Encapsulation leak sealing campaign.
See section Grit Blasting for PLCS Encapsulation for details or call PLCS.
|
1/2" Air Drill
Part # 49-A3025
|
High torque low speed (500-600 rpm) 1/2" Air Drill with a planetary gearing system used with a Jiffy Mixer required to properly mix the PLCS Encapsulation sealant.
Common air drills with a single gear drive run at 2000 - 3000 rpm free air speed. These will not have enough power to mix the sealant, especially in cold weather.
|
Small Jiffy Mixer
(for up to 5 liter mix)
Part # 10-542
|
The Jiffy Mixer used with the 1/2" Air Drill (49-A3025) is a heavy duty, extremely efficient stainless steel mixer
designed to quickly and thoroughly mix PLCS Encapsulation sealant.
The mixer has two sets of specially welded blades. The vertical blades keep the mixing action between them. The
horizontal blades move the sealant from the upper and lower areas of the container into the mixer head eliminating
unwanted aeration. The leading edge of the lower horizontal blade will scrape the bottom of the mixing container
to bring all settled material particles into the mixing head. All result in a thoroughly mixed Encapsulation sealant.
|
Medium Jiffy Mixer
(5 liter mix & larger)
Part # 10-544
|
Hand tool used to tighten and to apply the correct torque to the nylon bands included in 3" - 8" PLCS Low
Pressure Bell Joint Encapsulation Kits. The tool provides a mechanical advantage to secure the nylon ties
by squeezing the handles. The heavy duty tool is made from steel with padded foam grip handles to provide
comfort and a built in cutter to cut off the excess.
|
Tie Tool
(for nylon bands)
Part # 10-541
|
Hand tool used to tighten and to apply the correct torque to the nylon bands included in 3"-8" PLCS
Low Pressure Bell Joint Encapsulation Kits. The tool provides a mechanical advantage to secure the nylon
ties by squeezing the handles. The heavy duty tool is made from steel with padded foam grip handles to
provide comfort and a built in cutter to cut off the excess.
|
Band-It Tool
(for steel bands)
Part # 10-540
|
Hand tool used to tighten and to apply the correct torque to the steel bands included in PLCS Encapsulation Kits. The
robust dropped forged tool has a corrosion resistant blue epoxy coated finish with a built in cutter and spring loaded
gripper lever for easy operation.
|