|
PLCS Sensor Bags are the only balloon stoppers that can continuously monitor pressure in the main during shutdown,
without the need for an additional tap.
The bladder is held inside a synthetic fabric using a thin wall construction that permits mains entry through a
significantly smaller tapped hole than any competitive product.
|
- Sensor Bags record the internal bag pressure and continuously record the upstream pressure in the main throughout a shutdown operation
- The bags are barrel shaped to increase load on the pipe wall to retain position and at the same time increase the surface seal area to minimize gas bypass
- Sensor Bags are clamped to a semi-rigid inflation core to control entry direction and prevent reversal in the main or bag loss during sudden deflation
- Standard sizes are available for all cast iron and steel mains from 2"-48"
- Special sizes for PE plastic pipe
- Rated at 1¼ psi for mains up to 12"
- Available with rigid inflation control tee and rubber entry stopper
|
In an "open-hole" Double Block and Bleed shutdown, Sensor Bags are recommended for use in pairs at each end of the shutdown.
By using 2 Sensor Bags not only is the internal bag pressure recorded, but it is possible to confirm a zero pressure zone between
the bags as well as separately monitor the upstream and downstream mains pressures.
Sensor Bags can also be used in conjunction with ALH System-One tapping equipment to perform Gas-Free shutdowns.
|
|
|